- Qingdao Megatro Holding Co., Ltd.
- China Manufacturer with main products:transmission steel tower ,communication tower ,steel structure ,wind tubine tower ,steel mast ,power fitting and isulator ,conductor and earth wire ,lighting rod and earthing wire ,OPGW and cable ,aviation light ,anchor bolts and templates ,steel house and workshop
Home > Products > Above 500kv products(inclucing 500kv products) > Megatro Electrical power distribution
Megatro Electrical power distribution
- 4000 Ton / Tons per Month
- Qingdao or as per clients
- T/T L/C
- 30 days
Product Details
Brand Name: | Megatro | Place of Origin: | China | Model Number: | Megatro Electrical power distribution |
Product Description
Electric power distribution
Simplified diagram of AC electricity distribution from generation stations to consumers. Transmission system elements are shown in blue, distribution system elements are in green.
In the early days of electricity distribution, direct current (DC) generators were connected to loads at the same voltage. The generation, transmission and loads had to be of the same voltage because there was no way of changing DC voltage levels, other than inefficient motor-generator sets. Low DC voltages (around 100 volts) were used since that was a practical voltage for incandescent lamps, which were the primary electrical load. Low voltage also required less insulation for safe distribution within buildings. The loss in a cable is proportional to the square of the current, and the resistance of the cable. A higher transmission voltage would reduce the copper size to transmit a given quantity of power, but no efficient method existed to change the voltage of DC power circuits. To keep losses to an economically practical level the Edison DC system needed thick cables and local generators. Early DC generating plants needed to be within about 1.5 miles (2.4 km) of the farthest customer to avoid excessively large and expensive conductors.
Introduction of alternating current
General layout of electricity networks
The competition between the direct current (DC) and alternating current (AC) (in the U.S. backed by Thomas Edison and George Westinghouse respectively[2]) was known as the War of Currents. At the conclusion of their campaigning, AC became the dominant form of transmission of power. Power transformers, installed at power stations, could be used to raise the voltage from the generators, and transformers at local substations could reduce voltage to supply loads. Increasing the voltage reduced the current in the transmission and distribution lines and hence the size of conductors and distribution losses. This made it more economical to distribute power over long distances. Generators (such as hydroelectric sites) could be located far from the loads.
Contact Us
- Qingdao Megatro Holding Co., Ltd.
- Contact nameKarl
- Phone86-0532-55588298
- AddressHuangdao Qingdao,Shandong
- Cable short circuit and grounding fault indicator SNV-EKL3.2
- SNV-CX130 (80-120W) Intelligent Dehumidifier
- Cable short circuit and grounding fault indicator SNV-EKL3.2
- Electric power current fault indicator with short circuit and earth fault alarm SNV-EKL3.2
- Cable short circuit and grounding fault indicator SNV-EKL3.2
- How do Overhead Line Fault Indicator FPI Work?
- Cable short circuit and grounding fault indicator SNV-EKL3.2
- Cable short circuit and grounding fault indicator SNV-EKL3.2
- Best Fault indicator - Professional FI Manufacturer Intellegent Wireless Office System
- Cable short circuit and grounding fault indicator SNV-EKL3.2
- Cable short circuit and grounding fault indicator SNV-EKL3.2
- SNV-EFI power cable sensor earth fault indicator
- SNV-EKL4 V2.1 fault indicator cable power equipment
- SNV-EKL3.2 Short circuit and earth fault indicator with multigear
- what is Overhead line short circuit and grounding fault sensor ?SNV308 FPI
- Cable short circuit and grounding fault indicator SNV-EKL3.2
- SNV-EKL4 V2.1 short circuit fault sensor for distribution network
- Grounding Fault Sensor and Current Short Circuit Indicator
- SNV-EKL4 V2.1 Earth Fault Indicator cable sensor
- Electric Handcart and Ground Knife Integrated Protector
- Grounding Faul Indicator earth fault indicator
- SNV-EFI Earth Fault Indicator
- SNV-EKL4 V2.1 Earth Fault Indicator for MV Power Distribution Network
- SNV-EKL3.2 Earth fault and short circuit indicator
Popular Searches
Find Similar Products By Category
- Electrical Equipment & Supplies > Power Accessories
- Buy on GoldSupplier.com
- How to Buy
- Browse by Catagories
- Browse by Hot Regoins
- Private Sourcing Events
- Sell on GoldSupplier.com
- How to Sell
- Post Products
- Manage Products
- Manage Groups
- About
- About Us
- Link to Us
- Contact Us
- Sitemap
- Please Enter your Email Address
- Please enter the content for your inquiry.
We will find the most reliable suppliers for you according to your description.
Send Now-
Karl
Welcome to my shop! Glad to serve you!Please send your question!
Your message has exceeded the limit.
Your message has exceeded the limit.
-
-
Your inquiry content must be between 20 to 5000 characters.Send Now.
-
Please input the mailbox.
-