Automatic Ultrafine Powder Grinder with Ceramic Mortar

Advantages

1. Wear resistance: suitable for grinding any super hard particles (such as diamond);

2. Powder fineness: the longer the time is, the finer the powder will be. At the same time, the fineness of micron or nanometer level can be achieved by setting the time automatically;

3. High degree of automation, improve efficiency: replace manual grinding, save manpower, only a few minutes for each grinding;

4. Easy to use: small size, light weight, easy to move, convenient to pour materials, easy to clean mortar;

5. High cost performance: can compare the price of similar imported grinding equipment.

Applicable conditions

1. Requirements for abrasive particles: no limit on particle hardness, particle size ≤0.5mm;

2. Grinding method: dry grinding or wet grinding;

3. Grinding temperature requirements: There have been quite many successful cases for some special particles (or powders) that are flammable and explosive due to temperature rise in the grinding process, but the specific situations can only be determined after further communication or test with us;

4. Requirements for grinding amount every single time: this machinery is particularly suitable for the grinding amount under 50g (If the grinding amount needed is larger, TYM250 powder grinder from our company is strongly recommended);

5. Particles (or powder) suitable for grinding: micro powder of super hard materials (such as diamond wheel abrasive micro powder), electronic micro powder (semiconductor micro powder, polysilicon micro powder), resin micro powder; pharmaceutical micro powder, chemical micro powder (such as iodine micro powder), food micro powder (coffee powder), and so on;

6. Applicable power supply: 220V.

Working principles

1. The ceramic mortar is driven by a slow speed motor to rotate (the bottom of the ceramic mortar is a grinding surface that meets the grinding requirements, hard, wear-resistant and very smooth);

2. The ceramic grinding rod is tightly adhered to the bottom of the ceramic mortar under the action of the compression spring.

3. The grinding bar is driven by the fast speed reduction motor, and the slow speed mortar rotates in the opposite direction, automatically grinding the coarse particles by rolling.

4. The grinding time can be set automatically according to the needs. In order to achieve the required powder fineness, it can be grinded repeatedly for a long time or many times.

Spec Chart